via press release
The No. 11 team that competes in the NASCAR Sprint Cup Series has been penalized for a rules infraction discovered in post-race inspection July 27 at Indianapolis Motor Speedway.
This infraction is a P5 level penalty which is outlined in Section 12-4.5 A (9) of the 2014 NASCAR rule book:
Approved parts that fail or are improperly installed to fail in their intended use of great importance (e.g.; rear wheel well panels that fail and allow air evacuation in the trunk area; oil box cover that fails and allows air evacuation in the driver compartment; shifter boot cover that fails and allows air evacuation through the floor pan).
This infraction violates Sections:
12-1 - Actions detrimental to stock car racing;
20-2.1 – Car body must be acceptable to NASCAR officials and meet the following requirements:
· K – Any device or ductwork that permits air to pass from one area of the interior of the car to another, or to the outside of the car, will not be permitted. This includes, but is not limited to, the inside of the car to the trunk area, or the floors, firewalls, crush panels and wheel wells passing air into or out of the car;
· L – All seams of the interior sheet metal and all interior sheet metal to exterior sheet metal contact point must be sealed and caulked. This includes, but is not limited to, floors, firewalls, wheel wells, package trays, crush panels and any removable covers;
20-3.4 - All references to the inspection surface in sub-section 20-3.4 have been determined with the front lower edge of both main frame rails set at six inches and the rear lower edge of both main frame rails set at eight inches. For driver protection, all firewalls, floors, tunnels, and access panels must be installed and completely secured in place when the car is in competition;
20-3.4.5 - A rear firewall, including any removable panels or access doors, constructed using magnetic sheet steel a minimum of 22 gage (0.031 inch thick), must be located between the trunk area and the driver’s compartment and must be welded in place. Block-off plates/covers used in rear firewalls in place of blowers, oil coolers, etc., must be constructed of 22 gage (0.031 inch thick) magnetic sheet steel. Block-off plates/covers must be installed with positive fasteners and sealed to prevent air leakage. Carbon fiber or aluminum block-off plates/covers will not be permitted.
- - -
Per Section 12-4.5 B, the minimum P5 penalty includes: